3-Row Edging 1931 Marie Haase

3-Row Edging 1931 Marie Haase

3-Row Edging 1931 Marie Haase



In the pages of the Needlecraft Magazine 1931 Oct. pg. 31 Vol. XXIII No. 2 I found a set of three edgings designed by Marie Haase. As seen in the photo each of them was sewn to a header of fabric. This makes it easy to reuse the lace and sew it more easily to clothing, too. This one caught my eye as it looks rather like a line of dancers rapidly moving across the page.



illustration with ds count and order of work marked for Needlecraft Magazine 1931 Oct. pg. 31 Vol. XXIII No. 2 one of three edgings designed by Marie Haase



It is tatted in three rows with the first row being one shuttle work only and rows 2 and 3 being all chains. In two places the chain joins twice into one picot which created the look of a ring. It is important that the picots maintain regularity in length.



Row 1 using one shuttle or needle and ball thread begins with a ring.

R 6 - 6 - 6 - 6 close ring (clr) do not reverse work (dnrw)

Leave more or less 1/2" or 1.25 cm bare thread. Adjust length of thread to accommodate larger or finer thread. This thread will be basted to the header later.

*R 6 + (join to last picot of previous ring) 6 - 6 - 6 clr dnrw.

Repeat from * for length needed.



Row 2 is all chains so 2 shuttles may be used or one shuttle or needle and ball thread.

Attach thread to a joined picot of ring in row 1. Note in the photo that only the upper leg of the picot is used for the join.

CH **+ 7 + (join to middle picot of ring) 2 - 2 - 2 - 2 + (join to same picot) 7

Repeat from * across.
Note that the picots formed on the chain (which joins back on itself to look like a ring like a faux ring) need to be regular in length as they are highly visible.



Row 3 is an elaboration of row 2 with all chains so 2 shuttles may be used or one shuttle or needle and ball thread.

Attach thread to a picot of faux ring in row 2. Note in the photo the short chain between these joins.

CH ** 2 + (join to picot of faux ring in row 2) 2 - 2 + (join to middle picot of faux ring) in row 2) 2 - 2 - 2 - 2 + (join to same picot) 2 - 2 + (join to last picot of same faux ring)

Repeat from * * across.

illustration with ds count and order of work marked for Needlecraft Magazine 1931 Oct. pg. 31 Vol. XXIII No. 2 one of three edgings designed by Marie Haase



This is really cute and allows for personalization with beads or changes of thread color.




You Should Also Read:
More Edgings
Edging in 3 rows Maria Haase 1931
Wide 3-Row Edging 1931 Marie Haase

RSS
Related Articles
Editor's Picks Articles
Top Ten Articles
Previous Features
Site Map





Content copyright © 2019 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.